What does the error "Coincident Point" refer to when I Check Problems in Edit Extensions?

The Coincident Point error can occur after clicking on the Check Problems button in the Coincident Point error can occur after clicking on the Check Problems button in Exact Surfaces>Edit Contours>Edit Extensions.




To correct this issue zoom into the area until a black line appears near the point.


Select the Edit button under the Operation menu.



Place the cursor on the other side of the black line and not on the red point, and then drag the cursor across. This will correct the problem.


Rating:Rating of 3.5 Stars5 Votes
Was this answer helpful?YesNo

Geomagic Solutions

Topic Information
  • Topic #: 5605-1128
  • Date Created: 3/23/2010
  • Last Modified Since: 3/18/2014
  • Viewed: 1544
Welcome Guest
Help Desk and Customer Support Software by Parature