Skip To Search Skip To Main Content

Why am I getting an error when I try to use Autosurface/Extract Freeform?

Surfacing Error in Geomagic for SOLIDWORKS


Please try the steps below to resolve any error messages when using Autosurface or Extract Freeform:

1)  Open System Options > Import and uncheck the Enable 3D Interconnect option.
 
Note:  This option only exists in SW2018 and some versions of SW2017
 
2) If the issue is still occurring try launching the program in Safe Mode with SOLIDWORKS Rx.  
 

Note: If using safe mode resolves the issue then there must be another option causing the error.
Rating: 0 Votes 0 Yes Votes 0% voted yes
Was this answer helpful?
Provide Feedback on this Topic
Topic Information
  • Topic #: 5605-3287
  • Date Created: 01/12/2018
  • Last Updated: 01/12/2018
  • Viewed: 52
Why am I getting an error when I try to use Autosurface/Extract Freeform?
! ! ! !

Topic 5605-3287

Why am I getting an error when I try to use Autosurface/Extract Freeform?

Knowledge Base