Skip To Search Skip To Main Content

What does the error "Coincident Point" refer to when I Check Problems in Edit Extensions?

The Coincident Point error can occur after clicking on the Check Problems button in the Coincident Point error can occur after clicking on the Check Problems button in Exact Surfaces>Edit Contours>Edit Extensions.

 

 

 

To correct this issue zoom into the area until a black line appears near the point.

 

Select the Edit button under the Operation menu.

 

 

Place the cursor on the other side of the black line and not on the red point, and then drag the cursor across. This will correct the problem.


Rating: 5 Votes 4 Yes Votes 80% voted yes
Was this answer helpful?
Provide Feedback on this Topic
Topic Information
  • Topic #: 5605-1128
  • Date Created: 03/23/2010
  • Last Updated: 12/09/2014
  • Viewed: 1869
What does the error "Coincident Point" refer to when I Check Problems in Edit Extensions?
! ! ! !

Topic 5605-1128

What does the error "Coincident Point" refer to when I Check Problems in Edit Extensions?

Knowledge Base