Skip To Search Skip To Main Content

What does the "Angle" error mean in the Edit Extensions when I click on the Check Problems button in Exact Surfacing?

The Angle error can occur after clicking on the Check Problems button in Exact Surfaces>Contours>Edit Contours>Edit Extensions.

 

 

 

This error occurs when there is an angle that is not ideal for building a surface on because the Grid lines could become compressed resulting in a wrinkle in the surface. Below is an example of the error occurring. It appears the small angle, indicated by the arrow, needs to be adjusted to fix the error.

 

 

Adding a point by left-clicking on the line and then dragging it to make a bigger angle will create a better surface contour layout. Click Check Problems again to see if the error has been fixed.

 


Rating: 5 Votes 4 Yes Votes 80% voted yes
Was this answer helpful?
Provide Feedback on this Topic
Topic Information
  • Topic #: 5605-1056
  • Date Created: 03/10/2010
  • Last Updated: 12/09/2014
  • Viewed: 1890
What does the "Angle" error mean in the Edit Extensions when I click on the Check Problems button in Exact Surfacing?
! ! ! !

Topic 5605-1056

What does the "Angle" error mean in the Edit Extensions when I click on the Check Problems button in Exact Surfacing?

Knowledge Base